SPEC: 46305

CU Compressed 15kV NLEPR Insulation 133% IL Black LSZH-TP Jacket. MV 105 - Tray Rated - Sunlight Resistant - For Direct Burial

Type MV-105 Single Conductor Copper, 220 Mils No Lead Ethylene Propylene Rubber (NL-EPR) 133% Insulation Level, Tape Shield, Thermoplastic SOLONON® Low Smoke Zero Halogen (LSZH-TP) Jacket, Rated UL. Sans silicone

Télécharger les spécifications de la catégorie

Application & Features

Southwire’s 15KV cables are suited for use in wet and dry areas, conduits, ducts, troughs, trays, direct burial when installed with a grounding conductor in close proximity that conforms to NEC section 311.36 and 250.4(A)(5), and where superior electrical properties are desired. Ces câbles peuvent fonctionner en continu à une température de conducteur ne dépassant pas 105 °C pour un fonctionnement normal, 140 °C pour une surcharge d’urgence et 250 °C en des conditions de court-circuit. Peut-être utilisé à -25 °C pour des pliages à froid. Classé ST1 (faible émission de fumée) pour les tailles 1/0 et plus grands. Classé pour 454 kg./Pression latérale maximale FT.

Spécifications

Pour plus d’informations, sélectionnez un ensemble de produits ci-dessous :

	Cond. Dimensions	Cond. Strands	Diameter Over Conductor (in) (cm)	Diameter Over Insulation (in) (cm)	Épaisseur de l’isolation (mils) (mm)	Diameter Over Shield (in) (cm)	Épaisseur de la jaquette (mils) (mm)	Approx. OD (in) (cm)	Approx. Weight (lbs/1000') (kgs/km)	Max Pull Tension (lbs) (kg)	Min. Rayon de courbure (pouces) (centimètres)	Conduit Size (in) (cm)
More Options	1 AWG 1 AWG	19 19	0.322 0.82	0.800 2.03	220 5.59	0.860 2.18	80 2.03	1.040 2.64	739 1100	669 303.45	12.4 31.50	3.0 7.62
More Options	1/0 AWG 1/0 AWG	19 19	0.361 0.92	0.840 2.13	220 5.59	0.900 2.29	80 2.03	1.080 2.74	831 1237	844 382.83	12.9 32.77	3.0 7.62
More Options	4/0 AWG 4/0 AWG	19 19	0.512 1.30	0.990 2.51	220 5.59	1.050 2.67	80 2.03	1.230 3.12	1260 1875	1692 767.48	14.7 37.34	3.5 8.89
More Options	350 KCMIL 350 KCMIL	37 37	0.661 1.68	1.147 2.91	220 5.59	1.207 3.07	80 2.03	1.387 3.52	1795 2671	2800 1270.06	16.6 42.16	4.0 10.16
More Options	500 KCMIL 500 KCMIL	37 37	0.789 2.00	1.252 3.18	220 5.59	1.312 3.33	80 2.03	1.492 3.79	2329 3466	4000 1814.37	17.9 45.47	4.5 11.43
More Options	750 KCMIL 750 KCMIL	61 61	0.968 2.46	1.464 3.72	220 5.59	1.524 3.87	110 2.79	1.764 4.48	3358 4997	6000 2721.55	21.1 53.59	5.0 12.70
More Options	1500 KCMIL 1500 KCMIL	91 91	1.370 3.48	1.900 4.83	220 5.59	1.960 4.98	110 2.79	2.200 5.59	6031 8975	12000 5443.10	26.4 67.06

* Conduit size based on 3 phase 40% fill-factor without ground

	Cond. Dimensions	DC Resistance at 25C (ohms/1000') (ohms/km)	AC Resistance at 75C (ohms/1000') (ohms/km)	Capacitive Reactance (ohms/1000') (ohms/km)	Inductive Reactance (ohms/1000') (ohms/km)	Zero Sequence Impedance (ohms/1000') (ohms/1000')	Positive Sequence Impedance (ohms/1000') (ohms/1000')	Shield Short Circuit Current 6 Cycles	Allowable Ampacity In Duct 90C	Allowable Ampacity In Duct 105C	Allowable Ampacity In Air 90C	Allowable Ampacity In Air 105C
More Options	1 AWG 1 AWG	0.128 0.19	0.162 0.24	0.047 0.07	0.049 0.07	0.532 + j0.401 0.532 + j0.401	0.162 + j0.049 0.162 + j0.049	2695 2695	175 175	185 185	225 225	250 250
More Options	1/0 AWG 1/0 AWG	0.102 0.15	0.128 0.19	0.043 0.06	0.047 0.07	0.496 + j0.384 0.496 + j0.384	0.128 + j0.047 0.128 + j0.047	2816 2816	200 200	215 215	260 260	290 290
More Options	4/0 AWG 4/0 AWG	0.051 0.08	0.065 0.10	0.034 0.05	0.042 0.06	0.424 + j0.328 0.424 + j0.328	0.066 + j0.042 0.066 + j0.042	3284 3284	295 295	315 315	400 400	445 445
More Options	350 KCMIL 350 KCMIL	0.031 0.05	0.041 0.06	0.028 0.04	0.039 0.06	0.386 + j0.281 0.386 + j0.281	0.042 + j0.039 0.042 + j0.039	3770 3770	390 390	415 415	550 550	610 610
More Options	500 KCMIL 500 KCMIL	0.022 0.03	0.030 0.04	0.025 0.04	0.037 0.06	0.363 + j0.249 0.363 + j0.249	0.031 + j0.037 0.031 + j0.037	4167 4167	465 465	500 500	685 685	765 765
More Options	750 KCMIL 750 KCMIL	0.014 0.02	0.023 0.03	0.021 0.03	0.035 0.05	0.337 + j0.211 0.337 + j0.211	0.024 + j0.035 0.024 + j0.035	4752 4752	565 565	610 610	885 885	990 990
More Options	1500 KCMIL 1500 KCMIL	0.007 0.01	0.017 0.03	0.016 0.02	0.032 0.05	0.293 + j0.152 0.293 + j0.152	0.018 + j0.031 0.018 + j0.031	6010 6010	815 815	880 880	1345 1345	1500 1500

* NEC ampacities are based on:
* For Duct: Table 310.60(C)(11) Detail 1.
* For Free Air: Table 310.60(C)(3).
* Inductive impedance is based on non-ferrous conduit with one diameter spacing center-to-center.
* Sequence Impedance values are based on Rho Earth Resistivity: 100 Ohm-Meter/1000ft, Spacing: one diameter spacing center-to-center..
* Capacitive Reactance is between Phase-to-Shield.

Normes et références

ASTM B3 Soft or Annealed Copper Wire
Conducteurs en cuivre toronné à couche concentrique ASTM B8
Spécification ASTM B33 relative au fil de cuivre étamé mou ou recuit
ASTM B496 Cuivre rond compact concentrique standard
UL 1072 Câbles d’alimentation à moyen voltage
UL 1685 FT4-ST1 Test de propagation des flammes et émission de fumées sur chemin vertical (1/0 et plus grands)
UL 1685 Test de propagation des flammes et émission de fumées sur chemin vertical
ICEA S-93-639 (NEMA WC 74) Câbles d’alimentation blindés de 5 à 46 KV
ICEA S-93-639 (NEMA WC 74) Câbles d’alimentation blindés de 5 à 46 KV
Norme ICEA S-97-682 pour les câbles utilitaires blindés ayant des tensions nominales de 5 à 46 kV
IEEE 1202 FT4 Test de résistance aux flammes (70 000 Btu/h) sur chemin de câbles vertical (1/0 et plus grands)
AEIC CS-8 Specification for extruded dielectric shielded power cables rated for 5 through 46KV (Qualification Test Requirements)
NFPA 130 Standard for Fixed Guideway Transit and Passenger Rail Systems (500kcmil & Larger)
FABRIQUÉ AUX ÉTATS-UNIS : Compliant with both Buy American and Buy America Act (BAA) requirements per 49 U.S.C. § 5323(j) and the Federal Transit Administration Buy America requirements per 49 C.F.R. part 661

Construction

Conducteur : Class B compressed stranded bare copper per ASTM B3 and ASTM B8 (Tinned Copper per ASTM B33 optional)
Conductor Shield: Semi-conducting cross-linked copolymer
Isolation : 220 Mils No Lead Ethylene Propylene Rubber (NL-EPR) 133% Insulation Level,
Insulation Shield: Strippable semi-conducting cross-linked copolymer
Copper Tape Shield: Helically wrapped 5 mil copper tape with 25% overlap
Overall Jacket: Thermoplastic SOLONON® Low Smoke Zero Halogen (LSZH-TP) UL-1072 does not list polyolefin jacket. However, this LSZH meets the general definition of a thermoplastic polyolefin.

Ressources

Application Web Configurator Plus™